Setting Up Your Goodmans VCR
- Turn on your VCR and insert a tape.
- On your Tune In remote, press Vcr and release.
- Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
- Enter the first three-digit VCR code for your Goodmans from the list which follows:
278, 000, 020, 072, 037, 062
These codes are listed in order of popularity, and the green light will blink twice if you perform this procedure correctly.
- Aim Tune In at your VCR and press Power. Your VCR should turn off. If your original VCR remote control did not have a Power key, press Play. Your VCR should start to play. If your VCR does not respond, repeat steps 2-5, trying each code listed in step 4 until you find the one that operates your VCR.
Now Test Your VCR Code
- Press the Power key to turn on the VCR; then press channel scan ("CH"). Tune channels 7 and 11 by entering the number followed by the Enter key. Test all six (6) tape control keys.
- If your VCR does not pass the test, return to Step 2 at the top of this page. Enter the next three-digit code and repeat the process.
Return to |
 |
|
Return to |
 |
|