Setting Up Your Goldstar VCR

Remote

  1. Turn on your VCR and insert a tape.
  2. On your Tune In remote, press Vcr and release.
  3. Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
  4. Enter the first three-digit VCR code for your Goldstar from the list which follows:
    037, 038, 278
    These codes are listed in order of popularity, and the green light will blink twice if you perform this procedure correctly.
  5. Aim Tune In at your VCR and press Power. Your VCR should turn off. If your original VCR remote control did not have a Power key, press Play. Your VCR should start to play. If your VCR does not respond, repeat steps 2-5, trying each code listed in step 4 until you find the one that operates your VCR.

Now Test Your VCR Code

  1. Press the Power key to turn on the VCR; then press channel scan ("CH"). Tune channels 7 and 11 by entering the number followed by the Enter key. Test all six (6) tape control keys.
  2. If your VCR does not pass the test, return to Step 2 at the top of this page. Enter the next three-digit code and repeat the process.
Remote

Return to

Devices Set Up

Devices Set Up

Return to

Set Up VCR

VCR Selection.