Getting Started/Installing Batteries

To complete the Tune In setup process
You will need:

Your Tune In Remote Control
(4) AAA alkaline batteries
The Cable Conversion Chart for your cable system

Remote

Installing Batteries

Install four (4) new "AAA" alkaline batteries according to the diagram inside the battery box. Be sure to match the + marks inside the case.

Place the battery cover within 1/2 inch of the closed position; then slide the battery cover into place.

Remote

Check Battery Installation

Press key "5". The green light (LED) will flash once. Press the "Clear" key. The red light will flash.

Improperly installed batteries may cause acid leaks and/or damage to your Tune In.

 

TUNE IN!Back to Tune In Homepage