Setting Up Your NAD LD Player

Remote

  1. Turn on your LD player and insert a laser disk.
  2. On your Tune In remote, press Shift/Vcr and release.
  3. Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
  4. Enter code 059 for your NAD LD player. The green light will blink twice if you have performed this procedure correctly.
  5. Aim Tune In at your LD player and press Power. Your LD player should turn off. If your original LD player remote control did not have a Power key, press Play. Your LD player should start to play. If your LD player does not respond, repeat steps 2-5, using the code listed in step 4. If your LD player still doesn't respond, call (937) 866-9006 for help.

Now Test Your LD Player Code

  1. Press the Power key to turn on the LD player. Test all six (6) laser disk control keys.
  2. If your LD player does not pass the test, return to Step 2 at the top of this page. Using the three-digit code listed in step 4 repeat the process. If your LD player still doesn't pass the test, call (937) 866-9006 for help.
Remote

Return to

 Devices Set Up

Devices Set Up

Return to

 Set Up LD player

LD Player Selection.