Setting Up Your Gradiente 2nd VCR

Remote

Assign Key Sequence
"Shift", then "Vcr" to be a Second VCR

  1. Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
  2. Press and release keys: 9, 9, 2.
  3. Press and release the keys: Vcr, then Shift then Vcr.

Second VCR Set Up

  1. Turn on your second VCR and insert a tape.
  2. On your Tune In remote, press and release Shift, then press and release Vcr.
  3. Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
  4. Enter code 000 for your Gradiente VCR. The green light will blink twice if you have performed this procedure correctly.
  5. Aim Tune In at your VCR and press Power. Your VCR should turn off. If your original VCR remote control did not have a Power key, press Play. Your VCR should start to play. If your VCR does not respond, repeat steps 2-5, using the code listed in step 4. If your VCR still doesn't respond, call (937) 866-9006 for help.

Now Test Your 2nd VCR Code

  1. Press the Power key to turn on the VCR; then press channel scan ("CH"). Tune channels 7 and 11 by entering the number followed by the Enter key. Test all six (6) tape control keys.
  2. If your VCR does not pass the test, return to Step 2 at the top of this page. Using the three-digit code listed in step 4 repeat the process. If your VCR still doesn't pass the test, call (937) 866-9006 for help.
Remote

Return to

 Devices Set Up

Devices Set Up

Return to

 Set Up VCR

VCR Selection.