Setting Up Your Finlux 2nd VCR
Assign Key Sequence
"Shift", then "Vcr" to be a Second VCR
- Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
- Press and release keys: 9, 9, 2.
- Press and release the keys: Vcr, then Shift then Vcr.
Second VCR Set Up
- Turn on your second VCR and insert a tape.
- On your Tune In remote, press and release Shift, then press and release Vcr.
- Press and hold Set until the green light on Tune In blinks once, pauses and then blinks twice. Now release the Set key.
- Enter the first three-digit VCR code for your Finlux from the list which follows:
000, 042, 104, 081
These codes are listed in order of popularity, and the green light will blink twice if you perform this procedure correctly.
- Aim Tune In at your VCR and press Power. Your VCR should turn off. If your original VCR remote control did not have a Power key, press Play. Your VCR should start to play. If your VCR does not respond, repeat steps 2-5, trying each code listed in step 4 until you find the one that operates your VCR.
Now Test Your 2nd VCR Code
- Press the Power key to turn on the VCR; then press channel scan ("CH"). Tune channels 7 and 11 by entering the number followed by the Enter key. Test all six (6) tape control keys.
- If your VCR does not pass the test, return to Step 2 at the top of this page. Enter the next three-digit code and repeat the process.
Return to |
 |
|
Return to |
 |
|